Pooldex

Trichlor vs dichlor

Trichlor is about 90% available chlorine and adds 0.6 ppm of stabilizer (cyanuric acid, CYA) for every 1 ppm of chlorine; dichlor is 56% or 62% and adds 0.9 ppm. Trichlor tablets dissolve slowly and lower pH, while dichlor granules dissolve fast and are close to pH-neutral.

By Aliaksandr Rusinski · Updated October 11, 2026 · Formulas: methodology (last changed October 7, 2026) · Share

Always follow your product’s label directions. Pool and spa chlorine, bromine, shock, and algaecides are EPA-registered pesticides: use products labeled for pool or spa use, and don’t swim or soak until levels are within the limit on your product’s label. If this page and a label disagree, the label wins.

Pooldex, free for iPhone: save your pool and products, get wait timers and a retest reminder, and keep a log of every test. No ads, no account. Download on the App Store

On this page (6 sections)

Both are "stabilized chlorine": the cyanuric acid is part of the molecule, so every dose chlorinates and stabilizes at the same time. That is useful while CYA is low and a problem once it reaches your target, because only replacing water lowers it. Always follow the product label.

Trichlor vs dichlor at a glance

Amounts are for raising free chlorine (FC) by 1 ppm in 10,000 gallons, from our chlorine calculator.

Trichlor vs dichlor comparison table and a chart of CYA rising 8.4 ppm a week on trichlor and 12.6 ppm a week on dichlor, passing 50 ppm in week 6 on trichlor and week 4 on dichlor.
Per pound, trichlor carries more chlorine, but per 1 ppm of chlorine dichlor leaves 50% more stabilizer behind.
Trichlor vs dichlor compared
Trichlor (trichloroisocyanuric acid)Dichlor (sodium dichloroisocyanurate)
Available chlorineAbout 90%56% (dihydrate) or 62% (anhydrous)
Amount for +1 ppm in 10,000 gal1.5 oz (42 g)2.4 oz (68 g) at 56%; 2.2 oz (61 g) at 62%
CYA added per 1 ppm FC0.6 ppm0.9 ppm
Effect on pH and alkalinityLowers both; about −0.7 ppm alkalinity per 1 ppm FC as it is usedClose to neutral
Form and speed1 in or 3 in tablets and sticks; dissolves slowly in a floater or feederGranules; dissolve within minutes
Typical useSteady daily chlorine while you are busy or awayQuick doses in small pools; spa-labeled products for hot tubs
Hot tubsNo: spa makers advise against itYes, if the product is labeled for spa use
CostCompare price per ppm, not per bucket: chemical cost calculator

Available chlorine and CYA per ppm: PHTA fact sheets. Alkalinity loss from trichlor: reaction stoichiometry (our calculation). Doses: calculator results for fresh product at label strength.

Per pound, trichlor carries more chlorine: about 10.8 ppm of FC in 10,000 gallons against about 6.7 ppm for 56% dichlor. But per 1 ppm of chlorine, dichlor leaves 50% more stabilizer behind. So the question is rarely "which is stronger" and usually "how much CYA can my water still take."

What has more CYA: a season on each

The calculator projects stabilizer week by week if one of these is your only chlorine. Enter your CYA now and the chlorine your pool uses per day.

CYA buildup calculator

Inputs
ppm
ppmAbout what your pool uses per day if this is your only chlorine. Example value.
ppm CYAChlorine pools: 30–50 ppm. Salt water pools: 60–80 ppm.
weeks
More options (water replaced)
%Rain overflow, splash-out, backwashing. Example value: 0 means none.

Result for example values. Enter your own numbers.

CYA passes 50 ppm in

week 3+8.4 ppm a week

Switch to liquid chlorine before then, or plan to replace some water.

Projected stabilizer (CYA)
WeekCYAStatus
Week 138 ppmOK
Week 247 ppmOK
Week 355 ppmOver
Week 464 ppmOver
Week 572 ppmOver
Week 680 ppmOver
Week 789 ppmOver
Week 897 ppmOver
Week 9106 ppmOver
Week 10114 ppmOver
Week 11122 ppmOver
Week 12131 ppmOver
Week 13139 ppmOver
Week 14148 ppmOver
Week 15156 ppmOver
Week 16164 ppmOver

CYA added = 0.6 ppm per 1 ppm chlorine from trichlor. Water you replace dilutes it; otherwise it only goes up.

Save to my pool in the app

Estimates, not guarantees. Always follow the product label. How we calculate

Example from the calculator: a pool starting at 0 ppm CYA that uses 2 ppm of chlorine a day gains about 8.4 ppm of CYA a week on trichlor and 12.6 ppm a week on dichlor. It passes 50 ppm in week 6 on trichlor and in week 4 on dichlor. At 50 ppm, the minimum free chlorine is 4 ppm, and from there it keeps rising with CYA, as shown on pool chlorine levels.

Comparison of liquid chlorine, trichlor, dichlor, and cal-hypo: what each adds per 1 ppm of chlorine and how much stabilizer or calcium builds up over a season.
Trichlor and dichlor add stabilizer and cal-hypo adds calcium with every dose; liquid chlorine adds only a little salt.

pH and alkalinity

Trichlor is an acid. As it dissolves and its chlorine is used, it pulls pH and total alkalinity (TA) down, about 0.7 ppm of TA for every 1 ppm of chlorine. In a pool that also gets aeration from waterfalls or a salt cell, that can balance out the natural rise in pH. In a quiet pool with low alkalinity, it means adding baking soda regularly: see how to raise alkalinity.

Dichlor is close to neutral, which is why it is popular for spas and small pools, where a pH swing shows up fast. It does not fix pH either way.

When to use trichlor, dichlor, or neither

Which stabilized chlorine fits your water
Your situationUseWhy
New fill, CYA near 0, outdoor poolEither, until CYA reaches your targetBoth build the stabilizer that protects chlorine from sunlight
CYA 30–50 ppm, chlorine poolSwitch daily chlorine to liquid chlorine or bleach; keep tablets for tripsEvery dose of either keeps raising CYA
CYA above 60 ppmNeitherUse liquid chlorine or cal-hypo and plan a partial drain: how to lower CYA
Away for a weekTrichlor in a floaterSlow release; size it with the chlorine tablets calculator
Hot tubSpa-labeled dichlorFast, near neutral, small doses: dichlor calculator
Low alkalinity or low pHDichlor or liquid chlorine, not trichlorTrichlor pushes both lower

The other chlorine forms (liquid chlorine, bleach, and cal-hypo) and what each leaves in the water are compared on types of pool chlorine.

Safety

  • Never mix trichlor and dichlor with each other, with cal-hypo, or with anything else in a bucket, feeder, or floater. Mixed chlorine products can react violently and start a fire.
  • Never mix chlorine with acid: it releases toxic chlorine gas. Add each product separately, with the pump running.
  • Don't let tablets rest on a vinyl liner or a step, or in the skimmer basket, unless your label allows it; use a floater or feeder as the label directs.
  • Store them dry, sealed, apart from other chemicals, and out of reach of children. Wear gloves and eye protection.
  • Always follow the product label. It is a violation of federal law to use a pesticide product in a manner inconsistent with its labeling.
  • If someone swallows a product or gets it in their eyes, call Poison Control at 1-800-222-1222. More rules: pool chemical safety.

FAQ

What has more CYA, dichlor or trichlor?

Dichlor adds more stabilizer per unit of chlorine: about 0.9 ppm of CYA for every 1 ppm of free chlorine, against 0.6 ppm for trichlor (PHTA). Raising chlorine by 10 ppm with dichlor adds about 9 ppm of CYA; with trichlor, about 6 ppm.

Why is trichlor bad?

It isn't bad, but it has two side effects that build up. It raises CYA with every dose, and it lowers pH and alkalinity. Over a summer of tablets, CYA can climb past 50 ppm, which raises the chlorine level you need. Test CYA monthly and switch to liquid chlorine once you reach your target.

Should I use dichlor in my pool?

Yes, for a short time or a small pool: it dissolves fast and barely moves pH. It is a poor everyday chlorine for a large pool, because it raises CYA faster than any other form. Once CYA is 30–50 ppm, move daily chlorine to liquid chlorine or bleach.

Can you mix trichlor and dichlor?

Never in a bucket, floater, or feeder: chlorine products must not be mixed with each other. Using both in the same pool at different times is fine, for example tablets in a floater and dichlor added straight to the water, as long as you count the CYA from both.

Which dissolves faster, trichlor or dichlor?

Dichlor. The granules dissolve within minutes, so the chlorine is in the water right away. Trichlor tablets are made to dissolve over days in a floater or feeder, and a feeder's dial sets how fast (see pool chlorinator settings).

Is dichlor or trichlor cheaper?

Compare cost per ppm, not price per pound. Trichlor carries more chlorine per pound (about 90% against 56–62%), so it often costs less per ppm, but prices vary by store and package. Enter your own prices in the chemical cost calculator.

Sources

  • PHTA fact sheet, Dichlor (available chlorine, CYA per ppm): phta.org
  • CDC, Model Aquatic Health Code 2024, Annex (chlorine and CYA): cdc.gov (PDF)
  • CDC MMWR, Pool chemical injuries, 2008–2017 (never mix chemicals): cdc.gov
  • Taylor Technologies, K-1005 treatment tables: PDF
  • Doses, CYA projection, and formulas: our methodology page