Pooldex

How to drain an above-ground pool

To drain an above-ground pool, connect a garden hose to the pool's drain valve and let gravity empty it, or start a hose siphon or a submersible pump if there is no valve. First, check your local rules on where pool water can go. Intex says not to drain onto the lawn and to send it to a sewer or cesspool where that's allowed.

By Aliaksandr Rusinski · Published October 30, 2026 · Formulas: methodology (last changed October 7, 2026) · Share

Pooldex, free for iPhone: pick your Intex, Bestway, or Coleman model once, then see what to add after every test. No ads, no account. Download on the App Store

On this page (9 sections)

Draining time depends on your gallons and how fast water flows out. The calculator gives your pool's gallons from its model or size; the drain-time math is below.

Above-ground pool gallons

Inputs
ft
in
% of wall

Result for example values. Enter your own numbers.

4,426 gal16,753 L

Estimate: geometry 4,759 gal × 0.93 (typical ratio of real to nominal capacity for frame pools in our sample of 26 models). About ±7%.

Chemical amounts for about this size: 4,000-gallon pool dose chart.

Check your water for 4,426 gal: chlorine, pH, and alkalinity doses in order.

For the most accurate number, use your model's stated capacity or calibrate it: add a known amount of salt and measure how much the salt level rises.

Save to my pool in the app

Estimates, not guarantees. Always follow the product label. How we calculate

Before you drain

  • Decide: full or partial drain? To take the pool down for winter or move it, drain it fully. To lower stabilizer (cyanuric acid, CYA), salt, or calcium, you only need to replace part of the water; see how often to drain a pool for how much.
  • Check local rules. Intex tells owners to read local and special regulations on draining pool water. Many cities don't allow chlorinated water in storm drains.
  • Let chlorine drop if the water is going to a storm drain or the ground. Stop adding chlorine and leave the cover off in the sun for a few days, then test. EPA's model stormwater ordinance, which many cities adapt, allows pool water in storm drains only if it is dechlorinated, typically to less than 1 ppm chlorine. Your city's rule may be stricter.
  • Turn off and unplug the filter pump and any salt system or heater. They must not run dry.
  • Steel-wall pools with a vinyl liner: check the manual before emptying. A liner without water in it can shrink or pull out of its track, and some makers say never to leave the pool empty.

Method 1: the drain valve

Most frame and inflatable pools from Intex and Bestway have a drain valve near the bottom of the wall. From Intex support's instructions:

  1. Screw a garden hose onto the drain adapter (it comes with the pool) and run the other end to your approved drain spot, away from the house.
  2. Unscrew the cap on the outside of the drain valve.
  3. Push the adapter into the valve and screw it on right away. The adapter opens the plug inside, and water starts flowing.
  4. When the flow stops, lift the side of the pool opposite the valve so the last water runs toward it.
  5. Remove the hose and adapter, reseat the rubber plug from inside the pool, and replace the cap.

Method 2: garden hose siphon

A siphon works without a pump as long as the hose's outlet is lower than the pool's water level. Intex describes two ways to start one:

  1. Fill from the faucet. Connect the hose to the faucet, put the free end in the pool, and run water until it flows out into the pool. Keep that end under water, turn off the faucet, and unscrew the hose. Lay that end on the ground below the pool: water now flows out.
  2. Fill it in the pool. Sink the whole hose so the air comes out and it fills with water. Fold one end about 1 foot from the tip to hold the water in, carry that end to the low spot, and unfold it.

Never start a siphon by sucking on the hose: pool water contains chemicals. Siphoning slows down as the water level drops, because the height difference gets smaller.

Method 3: a submersible pump or the filter pump

  • Submersible (utility) pump: the fastest way for most above-ground pools. Set it on the pool floor on a flat spot, attach a discharge hose, and plug it into a GFCI-protected outlet. Stay nearby: switch it off before it runs dry. Intex also sells a drain pump for its pools.
  • Sand filter pump with a DRAIN or WASTE setting: Intex's sand filter pumps have a WASTE/DRAIN valve position that sends water out of the drain outlet without going through the sand. Turn the pump off before changing the valve, and stop before the water drops below the inlet fitting, or the pump will suck air.
  • Cartridge filter pumps on small above-ground pools usually have no drain setting. Use the drain valve or a siphon instead.

Pump details for Intex models are on the Intex pool pump guide.

How long it takes

Drain time (minutes) = pool gallons ÷ outflow (gallons per minute)

To measure your outflow, time how long the hose takes to fill a 5-gallon bucket. If it takes 1 minute, the flow is 5 gallons per minute (gpm); if it takes 2 minutes, it's 2.5 gpm. Example: a 3,000-gallon pool at 5 gpm takes 3,000 ÷ 5 = 600 minutes, about 10 hours. A gravity drain or siphon slows down as the water gets shallower, so the real time is longer than this estimate. The flow printed on a pump's box is usually more than you'll get through a long hose, so the bucket test gives the more accurate number.

Refilling takes about as long at the same hose flow. To estimate the water bill, use the pool fill cost calculator.

The last few inches

No drain valve or pump gets the last inch or two out. Intex's tips:

  • Frame pools (Metal Frame, Prism Frame, Ultra XTR): once the water is below about 4 inches (10 cm), remove one vertical leg and the horizontal beams. Then lower that side to the ground so the rest of the water runs out.
  • Inflatable and rectangular pools: lift the side opposite the drain, or use a siphon or drain pump.
  • Last puddles: use a wet/dry shop vacuum or towels. Dry the liner completely before you fold it, or it can grow mildew in storage.

Taking the pool down for winter? The rest of the steps, including folding and storage, are in how to close an above-ground pool.

Where the water can go

Rules are local, so ask your city or county. What the sources we checked say:

  • Intex: read local regulations; don't drain onto the lawn, because chlorine, salt, and other pool chemicals can harm grass; drain into a sewer or cesspool; send the water away from the house and other buildings.
  • EPA's model stormwater ordinance: pool water may go to a storm drain only if dechlorinated, typically below 1 ppm chlorine. Many local codes follow this idea, and some add limits on pH, salt, or flow rate.
  • Salt pools: salty water can harm plants and soil; your city may require the sanitary sewer.

Never let the water run onto a neighbor's property, into a septic drain field unless your system allows it, or against your house's foundation.

Safety. Keep children away from a draining pool: a partly full pool and a running pump are still hazards. Plug any electric pump into a GFCI-protected outlet and keep cords and plugs out of the water and off wet ground. Never start a siphon by mouth.

FAQ

How long does it take to drain an above ground pool?

Divide your pool's gallons by the outflow in gallons per minute. Measure the flow by timing a 5-gallon bucket. For example, 3,000 gallons at 5 gpm takes about 10 hours, and gravity drains slow down near the end.

How do you drain the last few inches of an above-ground pool?

On a frame pool, Intex says to remove one leg and the beams on one side and lower it once the water is below about 4 inches. On other pools, lift the side opposite the drain, siphon, or use a shop vacuum for the last puddles.

Can you drain a pool onto your lawn?

Intex recommends against it, because chlorine, salt, and other chemicals can harm grass. Local rules decide where pool water can go, so ask your city. If any water will reach a storm drain, it usually has to be dechlorinated first.

Can you drain an above-ground pool with the filter pump?

Yes, if it's a sand filter pump with a DRAIN or WASTE position, like Intex's sand pumps. Turn the pump off before turning the valve, and stop before the water drops below the inlet. Most small cartridge pumps can't do this.

Do you have to drain an above-ground pool completely to lower stabilizer?

No. Replacing part of the water lowers stabilizer (CYA) in proportion to how much you replace. The calculator on how to lower CYA gives the amount.

Sources

  • Intex Support, How can I drain the pool? (siphon methods, last 10 cm on frame pools): intexsupport.com
  • Intex Support, Getting the pool ready for winter (drain valve and adapter, local rules, not onto the lawn, sewer or cesspool, away from the house): intexsupport.com
  • Intex, Sand filter pump valve positions (WASTE/DRAIN): intexcorp.com (PDF)
  • U.S. EPA, Model illicit discharge and connection stormwater ordinance (swimming pools if dechlorinated, typically less than 1 ppm chlorine): epa.gov (PDF)