Pooldex

How many gallons is a 15x30 pool?

A 15 × 30 ft above-ground oval pool holds about 10,100–10,900 gallons, depending on the wall height.

By Aliaksandr Rusinski · Published October 7, 2026 · Formulas: methodology (last changed October 7, 2026)

On this page (7 sections)

By geometry at 90% fill, it holds about 10,800 gallons with a 48 in wall and 11,700 gallons with a 52 in wall. Real pools hold a little less. A 15 × 30 ft inground rectangle, 3.5–6 ft deep, holds about 16,000 gallons.

Quick answer for a 15x30

Which 15 × 30 do you have? The data block below treats it as an above-ground oval (straight sides with round ends) with a 48, 52, or 54 in wall. It also shows the frame-pool estimate (× 0.93). For a 54 in wall the estimate is 11,318 gallons. If your pool is an inground rectangle, skip to the next section.

15 × 30 ft oval pool: gallons at 90% fill
Wall heightGeometry (straight sides, round ends)Frame pool estimate (× 0.93)
48 in wall10,818 gal40,951 L10,061 gal
52 in wall11,720 gal44,364 L10,899 gal
54 in wall12,170 gal46,070 L11,318 gal

Oval above-ground pools are a rectangle with two half-circle ends. A true ellipse holds less.

Starting doses for 10,899 gal
ChangeAmount
+1 ppm FC (12.5% liquid chlorine)11 fl oz330 mL
+10 ppm TA (baking soda)1.55 lb693 g
+10 ppm CYA (stabilizer)14.6 oz413 g

Closest full chart: 10,000 gal dose chart.

Always follow your product’s label directions. Pool and spa chlorine, bromine, shock and algaecides are EPA-registered pesticides: use products labeled for pool or spa use, and don’t swim or soak until levels are within the limit on your product’s label. If this page and a label disagree, the label wins.

Above-ground oval vs inground rectangle

Same two numbers, three different pools. A 15 × 30 ft rectangle has 450 square feet of water surface. An above-ground oval of that size is a 15 × 15 ft rectangle with a half circle on each end. The rounded ends cut the area to about 402 square feet, 11% less. A true ellipse, the shape some calculators assume, cuts it further, to about 353 square feet.

15 × 30 ft: gallons by shape and depth
PoolDepthGallons
Above-ground oval, round ends52 in wall, 90% fill11,720 gal (estimate 10,899)
True ellipse52 in wall, 90% fill10,311 gal
Inground rectangle, flat4 ft13,465 gal
Inground rectangle, sloped3.5–6 ft15,990 gal
Inground rectangle, sloped3.5–8 ft19,356 gal

If you run an oval pool through an ellipse formula, you undercount by about 12% and every dose comes out short. The calculator lets you pick either oval type.

We don't yet have a manufacturer's listed capacity for a 15 × 30 oval. If your manual lists one, use it. Otherwise, the frame estimate is a reasonable place to start.

Starting doses for this volume

First doses: above-ground oval vs inground
ChangeOval, 52 in (10,899 gal)Inground, 3.5–6 ft (15,990 gal)
+1 ppm FC, 12.5% liquid chlorine11 fl oz16 fl oz
+1 ppm FC, 6% household bleach22 fl oz33 fl oz
+10 ppm TA, baking soda1.55 lb2.25 lb
CYA 0 to 30 ppm, stabilizer2.75 lb4.0 lb

Always follow the product label. It is a violation of federal law to use a pesticide product in a manner inconsistent with its labeling.

Full dose sheets near these volumes: 12,000 gallons for a 54 in oval and 15,000 gallons for the inground pool.

Calculator: your exact depth

The calculator opens as a 30 × 15 ft oval with a 52 in wall. Choose "True ellipse" only if your pool's sides curve all the way around with no straight section.

Oval pool volume calculator

Inputs
ft
ft
in
% of wall

Result for example values. Enter your own numbers.

10,899 gal41,258 L

Estimate: geometry 11,720 gal × 0.93 (typical ratio of real to nominal capacity for frame pools in our sample of 26 models). About ±7%.

Chemical amounts for about this size: 10,000 gallon pool dose chart.

Check your water for 10,899 gal: chlorine, pH, and alkalinity doses in order.

For the most accurate number, use your model's stated capacity or calibrate it: add a known amount of salt and measure how much the salt level rises.

Estimates, not guarantees. Always follow the product label. How we calculate

Fill time and water cost

Fill time is gallons ÷ hose flow. At 5 gallons per minute, the 10,899-gallon oval takes about 36 hours; at 10 gallons per minute, about 18. At the same flow rates, the inground pool (15,990 gallons) takes about 53 or 27 hours. Water cost is gallons ÷ 1,000 × your rate. For every $1 per 1,000 gallons, expect about $10.90 for the oval and $15.99 for the inground pool. Rates vary by town. Also ask your utility whether sewer charges apply to water used to fill a pool. The fill cost calculator does the math with your own rate.

Safety. Pour chlorine and acid separately in front of a return jet with the pump running, at least 30 minutes apart. Never mix products or add water to chemicals. Poison Control: 1-800-222-1222.

FAQ

How many gallons in a 30x15 oval pool?

About 10,818 gallons with a 48 in wall, 11,720 with 52 in, and 12,170 with 54 in, by geometry at 90% fill. Frame pools typically hold about 7% less: 10,061, 10,899, and 11,318 gallons.

How much chlorine for a 15x30 pool?

Per 1 ppm: about 11 fl oz of 12.5% liquid chlorine for a 52 in oval, or 16 fl oz for an inground pool 3.5–6 ft deep. Multiply by the ppm between your reading and your target.

Sources

  • Oval, ellipse, and rectangle formulas, correction factors, and dose math: methodology